![]() ![]() With multi-map missions like underground maze, underground palace, underground bridge hole, and dark graveyard, you'll face challenges at every turn. You can look up how to do all of these online.Introducing Skeleton Hunter: Survival 3D Game, a popular first-person offline horror adventure survival shooting mobile game! In this game, your mission is to destroy all the skeleton undead warriors and giant mutant spiders to survive and achieve the ultimate battle victory. ![]() A few other common handle wrapping types include fishtailing, simple looping, cobra wrap, and spiral/DNA wrap. It is very hard to explain how to do, so I recommend looking up how to do it, as there are people that have way more skill than me online. There are a ton of handle wrapping techniques, but the one that is most common for samurai swords is the traditional samurai sword wrap. If you Aren't satisfied with how your handle looks by now, you can wrap it. (Another finishing method is charring, which is where you char the outside of a handle to darken it.) After the epoxy had hardened, I used olive oil to finish the handle. After i had done this, I put the Tsuba and the handle together on the tang to make sure they fit right, and glued them with 5 minute epoxy. Then i marked out the shape of the tang on one end of the handle, and slowly removed material with it until it had a good fit on the tang. To Make the handle, I used a 1 inch diameter wooden dowel, then sanded down opposite sides of the dowel until it felt like it fit well in my hand. I gradually used these tools until I had a really good fit around the tang. After the holes were drilled, I connected and smoothed the edges with a Dremel and files. I then drilled out holes with a drill press, while making sure to stay inside the box that marked where the tang was going to go. ![]() After that, I found the center of the rectangle with a ruler, and marked out the shape of the tang at the center point. ![]() (Copper and brass are easier to work with than steel.) To make it, I cut out a 4x5 cm rectangle from an extra piece of steel I had, and rounded off all of the sharp corners. I chose to use steel for my guard, but you can also use brass or copper if you want. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |